Honeywell co detector manual

1. The detector will sound and illuminate per Table 2 and a smoke. alarm signal will be sent to the panel. 2. Verify the smoke alarm signal was received by the control panel. CO Test (Alarm Test) Press and hold the CO Test button for 1 to 2 seconds. The control. panel should display and sound a CO alarm. If carbon monoxide is still present after the 5 minute hush period, the audible alarm will sound. The hush facility will not operate at levels above ppm (parts per million) carbon monoxide. RealTest® Alarm Silence: Alarm will automatically silence after about 20 sec - onds of alarm from spraying canned CO into the detector. Alarm Reset: Alarm. View and Download Honeywell HEN instruction manual online. Carbon Monoxide Alarm HEN. HEN carbon monoxide alarm pdf manual download.

Dioxide, Sulphur Dioxide,Oxygen, Hydrogen Sulphide,Carbon Monoxide and Hydrogen. The transmitter features a display and three programmable relays for controlling external equipment e.g. alarms, sirens, valves or switches. The transmitter provides an industry standard 3-wire, mA source or sink output for connection to a dedicated gas detection. detect the presence of Carbon Monoxide. This manual contains information on the installation and operation of the Carbon Monoxide alarm. The status light flashes green at approximately 1 minute intervals to indicate that the unit is operating correctly. This will change to a yellow flash synchronised with chirp if a fault arises. View and Download Honeywell HEN instruction manual online. Carbon Monoxide Alarm HEN. HEN carbon monoxide alarm pdf manual download.

T User Manual. 2/ Honeywell. Limited Warranty. Exclusions. A. If Gas sensors are part of the Product, the gas sensor is. Where “Sensepoint Toxic” is mentioned throughout this manual, it refers to the Honeywell. Analytics Sensepoint product range of Toxic AND Oxygen gas sensors. CO Carbon Monoxide Detector with Built-in Wireless Transmitter. INSTALLATION AND SETUP GUIDE GENERAL INFORMATION.